Existing Electronics

Posted by ShadowRam April 12th, 2013

Good news! I figured I would have to purchase some micro limit switches. No need. All three axis have a through beam like sensor attached and already wired up.

20130411_114542

Wiring is already beautifully handled all through cable track. All nicely tucked away and protected.

Y - Track

Y – Track

X - Track

X – Track

There’s also a nice little panel in the corner of the frame. I may install the Arduino / RAMPS /Stepper Drivers module inside this box. All the steppers and limit switches are currently wired to the round jack. The DB25 looking pins are all hooked up to small control box on the Z-Carriage that I’m thinking about removing.

20130411_114558 20130411_114958

 

You must be logged in to post a comment.

Trackback URL for this entry